Putting in board and batten paneling in a toilet provides a conventional look. This layered design creates texture when mild catches the raised battens.
Make a simple DIY board and batten wall in a toilet by putting in one-by-four and one-by-six lumber straight on the lavatory wall. Caulk and latex paint make the board and batten wall waterproof and prepared for toilet use.
Earlier than You Start
When planning the board and batten structure, preserve these design suggestions in thoughts.
- Area the vertical battens 10 to 25 inches aside horizontally.
- Goal for 4 to 5 panels (the house between the battens) per 8 ft. Fewer panels look sparse, and extra panels look busy.
- Begin with one batten at every far facet, then work inward.
- Do not forget that 1x lumber (like one-by-fours) is at all times 1/2-inch narrower than its said width. One-by-fours are 3-1/2 inches extensive. One-by-sixes are 5-1/2 inches extensive.